Solid-state-logic X-EQ Manuel d'utilisateur télécharger pdf (Page 15)

Alternatively, you may wish to store the presets in a sub-

directory within your project folder.

A/B functionality, providing two different memory locations,

is included for easy comparison of any two settings. When the

plug-in is instantiate memory location A is selected by default,

as shown left. Pressing the A/B toggle button will move to

memory location B which allows you to set up a completely

independent EQ curve. Pressing the A/B button again will

return to A. You may wish to use this function to compare two

very similar settings or to keep a ‘maybe’ setting in reserve if

your current one does not work out.

You may wish to copy one memory location to another so it

becomes the starting point for a different setting you may wish

to explore.

Example: To copy from location A to location B:

1. Save the preset to a temporary location on your hard

disk whilst in location A

2. Toggle to location B

3. Load the stored preset

5.4 Meters

The X-EQ input and output meter displays are, in fact, three

meters in one. They offer various ways to easily read the Peak

and RMS levels of a signal over time, and the 'dynamic

history' meter allows you to see at a glance how the amplitude

has been changing over the past second or so. A 30dB range

from 0dB FS downwards gives ample information about the

amplitude of the signal.

Peak Meter and

Clip Indicaor

Dynamic History

Meter

RMS Meter

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 27 28

Pas de commentaire

Solid-state-logic X-EQ Manuel d'utilisateur Page 15